Nu Flow Presence on Six Continents
The Light Duty Electric Micro-Cutter is great when little cleaning and reinstating is necessary. It is light, compact, easy to use and can negotiate turns of 90 degrees.
The Light Duty Electric Micro-Cutter from Nu Flow is designed for indoor use of commercial, industrial and high-rise buildings, where it is difficult for pneumatic access. The foot pedal activated cutter runs at 110 volts with variable speeds in a variety of pipes from 2” to 6” in diameter.
The Pneumatic Micro-Cutter can be used to clean and remove pipe debris, calcite and roots from the inside of a variety of pipes including steel, cast iron and orangeburg. It is also good for reinstating.
The system rotates at approx. 2000 RPM in 1 ½” to 6” pipes in lengths up to 100 feet and will negotiate turns of 90 degrees in pipes down to 2” in diameter. It runs at 40 CFM and allows for multiple cutting heads.
The Mi-T-Cutter by Nu Flow is designed to cut open lateral reinstatements from the inside, as opposed to the branch line. It is also used for opening trapped drains and cutting our hard debris, and is ideal when there is a long distance to the access point.
Requires reasonable 7 to 10 CFM of air
Standard 110 volt outlet to power control box
Cutter is 32” in length
Best suited for 4” - 6” pipe
Cutter has bladder that locks it into place
Nu Flow Push Rods can be attached to position cutter into position
Camera holder is designed to fit Ridged camera head
Camera holder can be adjusted to any angle for optimal viewing